2ML PLUS CART MOD woot woot

[lightgeoduck]

Ok I had seen this concept awhile back from my man Carlos ... similarities but slight differences.... Soo I am not saying I invented or dreamed up a "new" idea,but I did figure it out on my own if you know what I am trying to say.

here is the vid and instructions below

1 306 atty (this is the model you use for your atty)
1 dummy 306 mouth piece closed end cut off
1 kr808 PT... could use a kr808 batt or 901 bat(i find the pt easier)
1 rubber ring from kr808 cart
1 roll of filler from kr808 cart (can use any filler type i.e. blue foam or what ever)
1 small juice/stiring non flex straw
1 801 dummy tip

gut PT take center post out from battery connection

insert straw put rubber ring around straw and push deep into kr808 tube

fill approx 2ml liquid (could try more,, but I was satisfied with this)

wrap filler around end of straw push straw and filler flush to tube
top off with liquid

insert mod 306 mouth piece into tube opening leaving enough room to slide on atty

cut excess straw from connector end put 801 dummy piece over battery connector

finished

Thank you and enjoy

[caesar]

Nice!

I don't have a 306 but I just realized that the same could be done to a KR808-D cartomizer, adding a lot of juice to it.

[lightgeoduck]

Nice!

I don't have a 306 but I just realized that the same could be done to a KR808-D cartomizer, adding a lot of juice to it.

if you are saying adding 2ml to a cartomizer, I would have to say that would only flood your cartomizer.... I use cartomizers as well and would have to say maybe 1ml is the max you should put in for quality production.... I haven't heard anyone put 2ml in the average carto with success

This mod could possibly hold more but I personally feel approx 2ml is enough

I will post pics later though

[natura]

My 510 ..came out wicked nice..my new cartos aren't getting much action now! Used a 1 pen, 1 straw,1 cart, and Nu-foam, Why I posted, was wondering anyone tried using a BOMBILLA for a juice/air chamber?